Meizu M1 NoteMeizu Mobile PhoneTeardown

Meizu M1 Note Teardown

In this guide, I’ll explain how to disassemble Meizu M1 Note to remove the LCD screen assembly, battery, rear camera, front camera, speaker and motherboard. Refer to this guide. You can repair your Meizu M1 Note.

Want to keep in touch with us? Follow us on Facebook for more repair news.

Remove two screws on both sides of the data line interface.

Pry up and open the LCD screen assembly.
Note: please be careful, the LCD cable still connected to the motherboard.

Disconnect the LCD cable. The LCD screen assembly can be removed.

Meizu M1 Note using the IGZO (indium gallium zinc oxide) LCD screen.

FT5346 touch chip

Remove all screws securing the middle frame.

Remove the screws securing the motherboard. There is a layer of metallic shield and graphite cooling stickers covered the chips of the motherboard.

The small board was integrated a vibrator, a Micro USB port, a home button and LED light.

Meizu M1 Note comes with a 3200mah, 11.78wh Li-polymer battery.

Remove the speaker module.

Dual color flash

The light distance sensor, power button, noise-canceling microphone are integrated into a small circuit board.

3.5mm headphone jack

5MP front camera and 13MP rear camera, both cameras come from Samsung.

Remove the metallic shield. You can find the chips.

MediaTek MT6752V 1.7GHz, Octa-Core processor, integrated Mali-T760 MP2 GPU and baseband chip, support for TD-LTE, FDD-LTE, WCDMA, TD-SCDMA, GSM network

Samsung 2GB RAM + 32GB ROM

MediaTek MT6169V RF chip

MediaTek MT6625LN chip, support Wi-Fi, Bluetooth, GPS, FM

MediaTek MT6325V power management chip

MediaTek MT6311P DC-DC chip

Skyworks 77621 RF chip, support GSM, WCDMA, TD-SCDMA, TD-LTE, FDD-LTE

Source: it168

Related Articles

12 Comments

  1. hi,
    i buy screen but it didnt has the place for scraws (sides of the data line interface) .
    how can i know which screen i should buy ?

  2. my front camera is having problem and i bought the spare part from china to repair it. But unfortunately the new 1 is still not working. Or got any steps need to do after installing new front camera in the phone?

    1. The code on my old front camera is
      P5V45B
      S
      B1447

      And code on new front camera is
      P5V45B
      S
      C1519

      Does the diference of code will cause not functining also?

      Or is there any probability of other hardware failure that causes dissability of front camera?

      Hope you can assist me in reparing the lfront camera

  3. Hi,
    I have a problem. I have replaced the screen of my m1 note but after that the proximity sensor is unable to calibrate so the gesture don’t work. There is any solution to fix this problem? Thanks

Leave a Reply to innotee Cancel reply

Your email address will not be published. Required fields are marked *

30  −  27  =