Meizu Mobile PhoneMeizu MX4

Meizu MX4 Teardown

In this guide, I’ll explain how to disassemble Meizu MX4 to remove the back cover, middle frame, battery, rear camera, front camera and motherboard. Refer to the guides, you can repair your Meizu MX4.

Want to keep in touch with us? Follow us on Facebook for more repair news.

First of all, remove the back cover.

Remove all screws securing the middle frame.

Once the middle frame was removed, you can access the internal components.

The flash light module is integrated into the middle frame. You can see MX4 uses the dual-LED flash, dual-LED flash first appeared on the iPhone 5s, it’s can provide a stable color temperature of light and shadow for the cell phone camera, making nighttime photographs more real.

Disconnect the battery power cable and remove the battery.
Meizu MX4 comes with a 3100mah battery, battery cells from Sony.

3.5mm headphone jack

The little motherboard is integrated data and micro USB charging port, microphone and antenna overflow outlet.

Sony IMX220 rear camera and Sony IMX208 front camera

MediaTek MT6595 eight-core processor was covered by a metal shield.

Toshiba 32GB eMMC memory chip

MediaTek MT6630QP RF chip. It supports dual-band Wi-Fi, Bluetooth 4.1, GPS / GLONASS / QZSS and FM signal receive.

Skyworks 77621-11 RF module, it supports GSM / GPRS / EDGE / WCDMA / TD-SCDMA and 4G networks

Samsung 2GB ROM

MediaTek MT6332P power management chip

MXP TF9890A speaker control chip

MediaTek MT6331P power management chip

Dialog DA9210 12A converter transformer

MediaTek MT6169V RF chip, mainly used for support the 4G

Related Articles

8 Comments

  1. hello meizu mx4 32gb lcd display screen connector to
    motherboard? or full motherboard fo meizu mx4. my phone connector pin
    broke i need help.

  2. Hi !
    My MX4 is stuck in bootloop. I want access to the fastboot mode but the bootloop consume battery faster than it charge, even with 2A charger and good usb cable. I removed battery in order to charge it manually only with cable, but I didn’t find the + and the – with multimeter (to small connector ?)
    What can I do to charge it succesfull ? If I charge battery via usb without the middle frame on it it don’t charge. So can I dissassemble all the phone and assemble it without the screen to reduce battery consuption ? Or can I weld 2 usb cables together in order to charge with 2 charger at the same time ?
    Thank you in advance and sorry for my bad english

  3. the speaker doesn’t work well, it works only with the earphones. What is the part to substitute?the speaker control chip??is it easy?

  4. Hi David,
    I just need your help. My MX4 is a defective batch and comes with touch screen issues. I have this 1cm line right in the middle that does not respond at all and makes cellphone act crazy. Is there any solution? i can’t simply replace the digiitizer right? Guess will need to sell the cellphone just like it is. I could buy a lcd+digitizer but i will probably end up with some shitty screen that will break anytime soon. Do you can tell me where i can buy a OEM screen? I really don’t understand why companies refuse to sell OEM parts.

    Cheers,

    Thanks

Leave a Reply to Sergio Kostylov Cancel reply

Your email address will not be published. Required fields are marked *

66  −  62  =