HP Envy 15HP Laptop

HP Envy 15-k000 disassembly and RAM, HDD upgrade options

In this guide, I’ll explain how to disassemble HP Envy 15-k000 to remove and replace the optical drive, hard drive, ram, keyboard, palm rest, wireless card, motherboard, heat sink and cooling fan. Refer to this guide, you can repair, upgrade and clean your HP Envy 15-k000.

Looking for more funny teardown? Follow us on Facebook for all the latest repair news.

In my case, the laptop model is HP Envy 15-k031tx.
Remove all screws from the bottom case. Pull out the optical drive.

HP Envy 15-k000 features an HL-DT-ST GU90N DVD burner.

Flip over the laptop.
Pry up the palm rest.
Disconnect the keyboard and touchpad cable. You can remove the palm rest and keyboard.

When the palm rest removed, you can access the motherboard, hard drive module and speakers.

Disconnect the USB board cable from the motherboard. Remove the hard drive module.

HP Envy 15-k000 comes with an HGST 1TB 5400RPM hard drive.

Remove the screw securing the wireless card.
Disconnect two wireless antenna cables.

HP Envy 15-k000 comes with an Intel Dual Band Wireless-AC 3160 wireless card. HP part number: 710662-001.

Envy 15-k000 speaker module

The motherboard has been removed.

HP Envy 15-k000 motherboard

Remove the RAM.

HP Envy 15-k000 comes with an SK Hynix 8GB RAM. HP part number: 693374-005.

Loosen seven screws securing the heat sink.

Remove the screw securing the cooling fan.

Envy 15-k000 heat sink and cooling fan, the cooling fan comes from Foxconn.

CPU and GPU

For more guides, check out the HP Envy 15-k000 device page.

Related Articles

7 Comments

  1. Did you wear an electro static discharge wristband when disassembling the laptop? If so, where did you connect it to?

  2. Hello,
    I am trying to replace my keyboard on this model. I tried prying up the arm rest however it is getting struck somewhere near the DVD area. I see there are three small screws once you remove the DVD drive. My question is, is it necessary to remove those small screws which is inside the laptop below the dvd drive or can I pry the arm rest without having to remove them?
    If you have a video or any other information on this regards would help. Thanks.

    1. Hello Banu
      You will have to remove those 3 screws below the dvd drive to remove the arm rest. Hope this helps.

  3. Not sure if this is still an active thread. I have a hp envy 15t-k100 laptop. Model G7Z03AV. It appears the hard drive has gone bad. I’m wondering if you could help me pinpoint exactly what hard drives are compatible with this unit. If I wanted to go SSD what are my options?

    1. I have this same model and I replaced the HDD with a Samsung Evo 650 500gb SSD and it works amazing. super fast. I highly recommend.

    2. Hey guys, hopefully, somebody can give me some inputs here. I am thinking of adding an SSD to this same model that I have and do you think there is an m.2 port on the Motherboard for an m.2 SSD? I understand it might be a SATA port rather than PCIe but that’s fine with me. Any feedback is appreciated!

Leave a Reply to Banu Prakash Cancel reply

Your email address will not be published.

77  −  72  =