Huawei Honor 6 Plus Teardown
In this guide, I will explain how to disassemble the Huawei Honor 6 Plus to remove the back cover, battery, rear camera, front camera, speaker, headphone jack, light distance sensor, and motherboard.
Want to keep in touch with us? Follow us on Facebook for more repair news.
Insert a pry tool under the back cover and slide it until the cover is completely separated from the phone.
The back cover of the Huawei Honor 6 is made of fiberglass.
The back cover has good toughness.
Remove all screws securing the middle frame.
Remove the top middle frame.
Remove the middle frame and graphite stickers.
The Huawei Honor 6 Plus has a 3500mAh Li-polymer battery, and the Huawei part number is HB4547B6EBC.
The 3.5mm headphone jack and the infrared transmitter port
Earpiece speaker, headphone jack, and light distance sensor
The volume button and power button are integrated onto a small circuit board.
Rear camera and front camera
Camera fixed base
Skyworks 77344-21 GSM/EDGE RF chip
Hisilicon Hi6401 Audio decoder chip
The Broadcom BCM47531 GNSS location chip supports GPS, GLONASS, QZSS, SBAS, and BeiDou.
Toshiba 16GB eMMC5.0 ROM
Hisilicon Kirin 925 1.8GHz processor and ELPIDA 3GB RAM
TriQuint TQP9058H power amplifier chip
AVAGO A924140 filter chip
Hisilicon Hi6361 4G LTE RF chip
Hisilicon Hi6421 Power management chip
Skyworks 13412 chip
Broadcom BCM4334 5GHz Wi-Fi + Bluetooth + FM Radio chip
Dual flash
Micro USB charging port
Vibrator module
Source: it168
Hello,
Do you know which camera sensor Huawei uses for the Honor 6 Plus?
Regards
Does anyone know what accelerometer and touchscreen it uses?
Where can I buy it, and how much is the front glass of the Honor 6 Plus?
Is there a tutorial on how to replace the glass?
Would it be advisable to replace the battery as well?
Thanks for your quick response.